Thread: Tools
View Single Post
Old 03-03-2012, 09:36 PM   #35 (permalink)
HeliFX
Registered Users
 
Posts: 1,279
 

Join Date: May 2009
Default

nice setup ZuvieleTeile

I was think using quick release high amp terminal blocks to connect motor to esc.
similar to the photo but single terminal for each connector.

has anyone used them and if so which ones where safe to use ?
any thoughts good or bad idea.

seem like a lot work to solder connectors each time you need to test a motor particularly ones configured with YY.



Quote:
Originally Posted by ZuvieleTeile View Post
Filling the boring waiting time for my wire, I remembered Stolla mentioning using an Eagle Tree Logger for his test stand.
Something dawned to me and after digging for a while in my drawers guess what I found?
Yes, an Eagle Tree V3 logger, which I almost forgot I had it.
Downloaded the latest software, fabricated two aluminum brackets holding a TDR motor mounting plate, mounted the hole thing on a sturdy piece of plywood, laid all the electronics out and fixed them in place and here we go.
First test run showed, that my 600 size X-era 4025/560 was just off by 9 RpM on the Kv.
Next I would like to see, if this differs when using a Jive.
Attached Thumbnails
Click image for larger version

Name:	9130k25p1l.png
Views:	382
Size:	11.7 KB
ID:	295659  
HeliFX is offline        Reply With Quote