View Single Post
Old 05-03-2012, 11:22 PM   #205 (permalink)
crash8384
Registered Users
 
Posts: 40
 

Join Date: Jun 2010
Default

check this out and tell me im not doing something right.

engine on the left is a running used one, engine on the right is mine that keeps throwing rods. try to see the 1-2mm diff between the tip of the rod journal to the rearward side of the channel cut out for lower rod clearance. its huge. also my rear bearing on the new updated case is shelded and the running engine is not. also the new back plate i was sent will not fit in the engine that throws rods but will fit in the engine that was sent to me today that runs fine.

in other words looking straight down on the old running engine the journal end is flush with the rear of the clearance channel. on the new engine there is a 1-2 mm space from the 2 points. can this cause my problem, another thing, why is my new updated case and bearing have a sheild on it anyways.

please tell me im not crazy here
Attached Thumbnails
Click image for larger version

Name:	2012-05-03 22.00.47.jpg
Views:	265
Size:	65.6 KB
ID:	313681   Click image for larger version

Name:	2012-05-03 22.01.01.jpg
Views:	243
Size:	65.9 KB
ID:	313682   Click image for larger version

Name:	2012-05-03 22.01.49.jpg
Views:	259
Size:	58.3 KB
ID:	313683   Click image for larger version

Name:	2012-05-03 22.02.02.jpg
Views:	249
Size:	46.5 KB
ID:	313684  
crash8384 is offline        Reply With Quote