View Single Post
Old 06-08-2012, 04:43 PM   #35 (permalink)
DoubleCH
Registered Users
 
Posts: 7,689
Thread Starter Thread Starter
 
My HF Map location
Join Date: Sep 2011
Default

Make sure tail gain is set to 1. Anything lower you'll not get max thrust from that motor. Anything higher OTOH you reach the same max thrust as gain=1.0 just sooner. No preference on BLHeli tail version. They all work fine using default values. The only version-particular problem is with 3.3 that has very muted motor beeps. Not sure what you mean by version 1 hp03t. As long as it's 12-magnet version it should be good. Not sure why you don't get good thrust. Make sure tail prop is not spinning on the shaft. On every brushless tail build I have to CA the prop on the shaft. The 12-magnet motor has more torque than even 120SR tail motor that it will spin the prop on hard acceleration and deceleration, especially with damp mode (default).
DoubleCH is offline        Reply With Quote