View Single Post
Old 09-27-2012, 08:11 PM   #9 (permalink)
HF Support
Posts: 14,099
Thread Starter Thread Starter

Join Date: Sep 2006
Default Rotor Head

Rotor head comes assembled and a very nice piece of kit it is too. I checked the spindle and see-saw bolts to see if they were Loctited (they were) and didn't disassemble further.

Using the specified swash-servo links the swash sat 18mm above the top bearing block so I made up a Delrin spacer and used that to square up the washout and mixer arms. The ball links were pretty tight so the head is quite stiff - I'll see if they wear in, if not I'll size them using a ball-link reamer. I changed the supplied threaded jesus bolt to a sleeved variety and popped in a couple of nice Kasama washers as it was a bit long.

Video 4 - Quest Impaction E12 - Rotor Head - mp4 193MB

Attached Thumbnails
Click image for larger version

Name:	PIC_0001.JPG
Views:	5409
Size:	97.5 KB
ID:	353097   Click image for larger version

Name:	PIC_0006.JPG
Views:	4908
Size:	94.6 KB
ID:	353099   Click image for larger version

Name:	PIC_0010.JPG
Views:	5066
Size:	94.1 KB
ID:	353100   Click image for larger version

Name:	PIC_0011.JPG
Views:	4982
Size:	97.1 KB
ID:	353101   Click image for larger version

Name:	PIC_0014.JPG
Views:	4801
Size:	94.6 KB
ID:	353102  


Last edited by Jason Cole; 01-23-2020 at 09:43 AM..
Mercuriell is offline        Reply With Quote