View Single Post
Old 10-23-2007, 10:24 PM   #4 (permalink)
SB
Registered Users
 
Posts: 143
Thread Starter Thread Starter
 
My HF Map location
Join Date: Apr 2007
Default

Step 15: drill out the whole where the neck strap loop used to be for the size of your led. in my case it was 11/64"


Step 16: Solder your wire to the LED. USE HEAT SHRINK! the long leg of the LED is positive, the short is negative. cut the leads down as you don't need them that long. (if you cut both of them the same length and forget which is which on a 5mm round led there will be a flat side on the clear part, the leg on this side is negative)


When your done it should look all pretty


Step 17: Feed the LED and wire through the whole in the mane frame of the radio.


you might have to modify the size of the whole to get the shrink tubing to fit. (i had to)


Step 18: Place the silver Face Plate back on the radio, lining up all the tabs on top and the new led in the whole.


Should look nice when your done
Attached Thumbnails
Click image for larger version

Name:	dx7 044.JPG
Views:	11371
Size:	97.0 KB
ID:	29188   Click image for larger version

Name:	dx7 048.JPG
Views:	11314
Size:	66.1 KB
ID:	29189   Click image for larger version

Name:	dx7 050.JPG
Views:	11246
Size:	48.1 KB
ID:	29190   Click image for larger version

Name:	dx7 052.JPG
Views:	11343
Size:	95.9 KB
ID:	29191   Click image for larger version

Name:	dx7 053.JPG
Views:	11210
Size:	90.3 KB
ID:	29192  

Click image for larger version

Name:	dx7 054.JPG
Views:	11232
Size:	97.8 KB
ID:	29193   Click image for larger version

Name:	dx7 055.JPG
Views:	11222
Size:	89.3 KB
ID:	29194  
__________________
Night Flight - Fly Hard! Fly Fast! Fly Dark!
SB is offline        Reply With Quote