View Single Post
Old 10-09-2012, 10:39 PM   #5 (permalink)
EEngineer
Registered Users
 

Join Date: May 2012
Default

Quote:
Originally Posted by Temptation View Post
I will be checking again as I do repairs, but I was unable to feel anything. I just wanted to know if there was a way to check other then what I have already done. Powering up and doing some stick movments seem to be fine. Powering down and moving the servos with m hand I don't feel anything. Also I don't really see why you have to reset the beastx after changing a gear? If everything goes back to the same place why would it matter?
You touched down without using the skids......the 450X is not an MCPx.....

Once you've replaced the parts that you listed.....you will have to spool up...on the bench....without blades(main and tail).....to see if there are no unusual vibrations....

There might be a part that's damaged, but not easy to spot....

You should balance your new blades.....

Most of your ARBX settings are Ok......but, you should at an absolute minimum......

Go through ARBX Setup Menu ..... Steps G, J, K, and L....and that's if you don't replace or re-gear your stock servos......and you're going to need a pitch gauge.....

And, since you didn't mention damage to the tail assy., a full ARBX Setup is a wise thing to do.....

FWIW
EEngineer is offline        Reply With Quote