Quote:
Originally Posted by EEngineer
You touched down without using the skids......the 450X is not an MCPx.....
Once you've replaced the parts that you listed.....you will have to spool up...on the bench....without blades(main and tail).....to see if there are no unusual vibrations....
There might be a part that's damaged, but not easy to spot....
You should balance your new blades.....
Most of your ARBX settings are Ok......but, you should at an absolute minimum......
Go through ARBX Setup Menu ..... Steps G, J, K, and L....and that's if you don't replace or re-gear your stock servos......and you're going to need a pitch gauge.....
And, since you didn't mention damage to the tail assy., a full ARBX Setup is a wise thing to do.....
FWIW
|
Lol... I don't know if I would use the words touch down....lol it may have been a little more then a touch
, but I did kind of use one side of the skid after the bounce...
lol