View Single Post
Old 09-10-2013, 08:09 PM   #1 (permalink)
Dmor
Registered Users
 

Join Date: Jan 2013
Default 5065MG Rebuild problem. Looking for some help.

Just rebuilt 2 of those servos. Followed the pictorial instructions on this site. What I have done is contact cleaning, complete gear replacement (all), dielectric grease on all gears and reassembled.
Using the elevator channel on my FBL unit, I plug the servo with horn on, cycle and start moving the sticks. The elevator (rebuilt) servo works and responds fine for about 7 seconds or so and then stops. It is not connected to anything. Second servo does the exact same thing.

What could possibly by the problem. I know it has to be in the rebuilt servos. I have checked and swapped servos and channels, and all is good.

Thanks for any tips.
__________________
450x-HC3XS ***** DX8
Dmor is offline        Reply With Quote