Thread: Simulator setup
View Single Post
Old 09-28-2013, 07:33 AM   #25 (permalink)
brw0513
Registered Users
 

Join Date: Mar 2005
Default

Thanks ArchmageAU - I've had some success.

I'm using a SAILI USB "9 in 1 dongle" set to position 2 (=AeroFly) on the 4 position switch. No problem with loading the Trex600-6S model and flying around (using 5 channel option during the calibration process).

I can't get the Hover Training to work though - if I could I'd gladly pay the fee for the full version of the software.

Is Hover Training disabled in the free version or is there something specific required to start the model? There is a chance I haven't assigned the "buttons" correctly and perhaps this is a necessary step to get the model in the air to start training?
brw0513 is offline        Reply With Quote