View Single Post
Old 03-02-2014, 07:28 PM   #24 (permalink)
SamIAm
Registered Users
 

Join Date: Feb 2012
Default

I'm looking into producing some -17 and -18 gears in nylon and carbon steel. Without these gears, the rest of the parts are useless. Raptor 90 booms should fit and the torque tubes are just arrow shafts. Main shafts are easy and main gears are simple as well, not that you strip them much. Spindles will be a bit trickier but not impossible. Pitch arms should be doable, head blocks are hard. Main frames are easy, bearings are easy, tail output shaft is easy.
__________________
Lots of X-Cells and little sense.
SamIAm is offline        Reply With Quote