View Single Post
Old 05-01-2014, 06:32 AM   #14 (permalink)
stablehover
Registered Users
Thread Starter Thread Starter
 

Join Date: Mar 2011
Default

So just to make sure I was covered in my original question or post I ordered some Xtreme A's and B's to cover my bases so to speak. For you guys that run the Xtreme A gear should I have any concern about circumference and the elevator servo?

Also for vtown nick do you run an aftermarket metal case? Both my tailcases are stock Blade and they are pretty much impossible to move around. I went back to the stockers after wearing out two LYNX metals. My gear mesh is fine. I do not think I could move my tailcase if I wanted to especially with the LYNX TBSR booms. Lot of friction in that fit. I have reverted to almost all stock on both my 130's
stablehover is offline        Reply With Quote