View Single Post
Old 05-01-2014, 12:36 PM   #16 (permalink)
vtown nick
Registered Users
 
Posts: 5,760
 

Join Date: Feb 2013
Default

Quote:
Originally Posted by stablehover View Post
So just to make sure I was covered in my original question or post I ordered some Xtreme A's and B's to cover my bases so to speak. For you guys that run the Xtreme A gear should I have any concern about circumference and the elevator servo?

Also for vtown nick do you run an aftermarket metal case? Both my tailcases are stock Blade and they are pretty much impossible to move around. I went back to the stockers after wearing out two LYNX metals. My gear mesh is fine. I do not think I could move my tailcase if I wanted to especially with the LYNX TBSR booms. Lot of friction in that fit. I have reverted to almost all stock on both my 130's
The xtreme A seems just the slightest bit smaller outer diameter that the hh metal one. Tho if you have newer servos this wouldn't be an issue.

Sorry about that, yes I only run the lynx quad tail case on all 3 of my helis. 100s of flights and 1,000s of crashes on original bearings still going strong! Setting the depth with a stock case is a real chore but possible. I do it by pulling the boom out of the frame to get the fit right because you end up ripping the tail cause off when it finally does move.
__________________
Team MSH USA - Cyclone Blades
MSH Prtos 380 Brain 2
MSH Prtos Max V2 Brain
vtown nick is offline        Reply With Quote