View Single Post
Old 06-02-2014, 09:11 PM   #3 (permalink)
Mentalic
Registered Users
 
Posts: 2,450
 
My HF Map location
Join Date: Apr 2008
Default

Quote:
Originally Posted by B.Ewing View Post
Ok guys, i am trying to figure out the cause of a recent crash on my E7. My first crash on this airframe after a year and a half on one setup. I got a "low voltage of 3.3 rail" message as the first error message before some "sensor out of range" type messages. My setup is a 2s 2000mah 20c lipo Y'd into a silver V-bar. Sbus receiver, futabe HV servos. I dont see anything wrong with my wiring to my other electronics, which leads me to believe that i might have just experienced a sag in a lipo that might be wearing out. thoughts?

So what do you think? plausible? Or do i need to keep looking
Lipos do go bad but it could be a servo too. Test it on the bench by setting pitch pump to 100 and slam the collective and see if you can reproduce the failure.
__________________
Wayne

Logo 480 / Logo 600sx / Logo 690 / Logo 700 / Vbar Control
Mentalic is offline        Reply With Quote