View Single Post
Old 08-29-2014, 09:52 AM   #12 (permalink)
WyDiablo
Registered Users
 
My HF Map location
Join Date: May 2008
Default

This is the best answer for setting up a fail safe for a DX7 that I have run across.

Quote:
Originally Posted by LL-Cool-T
Im trying to put the AR8000 into failsafe mode using the AR8000rx...I can manually put it in because I programmed a switch to do it...now I need to make it work when I turn off my DX7...HELP !!! Thank You.

Place your radio switches so they are or would be in failsafe mode and leaving throttle at 50%. Leave it off now turn off your radio.

Next, insert your bind plug into the rx. Power on the rx/naza. After 2-3secs remove your bind plug from the rx.

Now, turn on your radio holding the bind switch and bind to the rx like your normally would but now with your radio "in" the failsafe position.

After it binds, power off the rx and place your radio switches back to "normal".

Power cycle your radio and power on your rx/naza.



Lastly, check and verify in the naza assistant that when you turn off your radio it enters failsafe before you go test fly!!!
Make sure your sliders light up the fail safe in blue and then rebind your tx with it connected to the naza assistant just like you did above. After that check it on the assistant by turning off your tx.
WyDiablo is offline        Reply With Quote