View Single Post
Old 08-30-2014, 10:03 PM   #14 (permalink)
mmarian
Registered Users
 

Join Date: Aug 2007
Default

Quote:
Originally Posted by WyDiablo View Post
This is the best answer for setting up a fail safe for a DX7 that I have run across.

Quote:
Originally Posted by LL-Cool-T
Im trying to put the AR8000 into failsafe mode using the AR8000rx...I can manually put it in because I programmed a switch to do it...now I need to make it work when I turn off my DX7...HELP !!! Thank You.

Place your radio switches so they are or would be in failsafe mode and leaving throttle at 50%. Leave it off now turn off your radio.

Next, insert your bind plug into the rx. Power on the rx/naza. After 2-3secs remove your bind plug from the rx.

Now, turn on your radio holding the bind switch and bind to the rx like your normally would but now with your radio "in" the failsafe position.

After it binds, power off the rx and place your radio switches back to "normal".

Power cycle your radio and power on your rx/naza.



Lastly, check and verify in the naza assistant that when you turn off your radio it enters failsafe before you go test fly!!!
Make sure your sliders light up the fail safe in blue and then rebind your tx with it connected to the naza assistant just like you did above. After that check it on the assistant by turning off your tx.
This has been discussed and instruction given many times before. To the instruction above only adding that the relevant end point of the chanel assigned to the flight switch need to be adjusted for the cursor to be in blue failsafe area in the assistant software before binding. Than after the failsafe is set, the end point needs to be returned to the previous value for the control switch to move the cursor to all three fligt modes Manual, Atti. and GPS.
mmarian is offline        Reply With Quote