View Single Post
Old 02-27-2015, 10:14 PM   #1 (permalink)
WyDiablo
Registered Users
 
My HF Map location
Join Date: May 2008
Default Pixhawk gimbal connection

I'M ready to connect my single axis gimbal to the pixhawk and I was reading the instructions here.

Connecting the Servos to a Pixhawk
Connect the gimbal to Pixhawk’s auxiliary output pins. Connect tilt (pitch) to aux out signal (s) pin 1, roll to aux out signal (s) pin 2, and ground to an aux out ground (-) pin.

So I take it that I need to remove the (red) positive wire from the servo cable. Because reading the instructions it only uses the ground and signal pins correct.
WyDiablo is offline        Reply With Quote