View Single Post
Old 04-12-2015, 07:14 PM   #77 (permalink)
ArchmageAU
HF Support
 
Posts: 6,850
Thread Starter Thread Starter
 
My HF Map location
Join Date: Jan 2013
Default

Quote:
Originally Posted by rishalkant View Post
Hello
thanks for reply. yes i have enough hard drive space. last night i tried it on my laptop also and same issue.

it detects my controller but no planes or heli in the field,
its very frustrating

some people say to put the controller in ppm mode, i cant do that on my dx6
i should had bought the dx6i (would had been better and easier)

Would know how to turn that setting on or of on a dx6.
thanks
According to the DX6 manual, Wired trainer should be set to INHIBIT and Wireless Trainer set to INHIBIT. By default the Wired trainer is INHIBIT.

If the Wired trainer is set to SLAVE, it expects the master to be a Pilot Link style of master. (Which Phoenix is not).

With Wired trainer set to INHIBIT, the PPM signal should be sent through the 3.5mm audio trainer jack at the back of the transmitter.

To activate, first set the Wired trainer to INHIBIT, then turn the DX6 OFF. Yes OFF. Then plug in the Phoenix cable into the back of the DX6 and it should turn on and start sending PPM signals to Phoenix.

You may have to go through a full calibration, but at least now you should be able to get it to work.

Note: Trainer on DX6 (or DX6i) will not work as a slave (or with Phoenix) if the TX is turned on when a cable is plugged into the trainer port.
__________________
TRex 700E Pro DFC HV (BD3SX) - Gaui X5 (6S/BD3SX), Blade 130X, RealFlight, Heli-X, Taranis+DSMX
ArchmageAU is offline        Reply With Quote