View Single Post
Old 11-14-2015, 04:45 PM   #67 (permalink)
MrHux
Registered Users
 

Join Date: Oct 2015
Default

Hi guys,

I need some clarity to this calibration procedure after the firmware update. I too recieved my cable yesterday and updated the firmware to the latest available (4.23). I did the calibration as listed and to the word, and it appears to complete sucessfully.
My question is, given the tx needs to be in FM1 this would suggest the rx uses the input values to enter the calibration mode, but if throttle hold is ON, line 3 in the procedure there are no changes to the values seen in the monitor on the tx when switching from normal mode to FM1.
Also worth mentioning, since doing the calibration and spooling up the heli in my hand it too wants to tip over, to the right in my case.
So given the motors are unplugged should throttle hold be on or off?

Many thanks
Mark
MrHux is offline        Reply With Quote