View Single Post
Old 08-27-2016, 03:58 PM   #37 (permalink)
robert808
Registered Users
 

Join Date: Jun 2016
Default

My linear servo was not centering and staying near the bottom so that I had very little positive pitch. I tried all forum suggestions short of replacing servo. Then after reading a post about the function of the resistor strip next to the contact strip in the servo it hit me. I found out that when I cleaned the contact strip and wiper, the wiper must have shifted in the holder that travels on the screw gear. I pushed the wiper back in the slot all the way and servo good to go. Centers again. Thanks to the many posts that helped me resolve my issue. Hope this helps someone else.
robert808 is offline        Reply With Quote