View Single Post
Old 09-08-2016, 05:52 AM   #35 (permalink)
Registered Users
Posts: 2,081
My HF Map location
Join Date: Mar 2011


Your gyro was driving the tail servo without any heading correction, thus overdriving the servo.
Best to unplug the tail servo from the gyro until your ready to set up the tail.

I went back a few pages, had a look at your specs. it appears your using a hitec hs56hb for the tail, is that correct?

If so remove it and replace it with a proper tail gyro. the 56hb will not be up to the task.
In fact I use to fly the Hitec HSG5084's which is a dedicated tail servo and they where never up to the job. They claimed they run @ 1520 but I would fry them at anything over 720.

In the mean time look this over......

///-------TEAM FLYBAR-------///
ERRATIC is offline        Reply With Quote