View Single Post
Old 09-28-2016, 03:12 PM   #13 (permalink)
Registered Users
Posts: 146

Join Date: Jan 2014
Default Arduino current sensor - How To

Yeah that would save a lot of hassle getting the info direct from the esc...

I built an ec5 version now. This weighs 40g with arduino and cables:

Do you have any suggestions on how to calibrate the current sensors? I don't have a multimeter that goes very high.

Is it best to use a power resistor and measure the voltage and calculate the current (using V=IR) and compare to s.port value?

Sent from my iPhone using Tapatalk
Gaui X3 - KST cyclics, MKS tail, YEP esc, Align motor, 6s Gens ace
Goblin 570 - Mks, Kde motor, 12s Gens ace
...and some planks too!
Trebb is online now        Reply With Quote