View Single Post
Old 11-22-2016, 02:24 AM   #6 (permalink)
HF Scale Support
Posts: 4,080

Join Date: Jan 2010

When I did my AS350, I used the Nitro shaft and a short head from Century. It put the head about perfect so this head, even with the two holes, should do the job. Drill the second hole if you need it but in my opinion, one should do the job as you are not rotating the head at 3D speeds and you are not stressing it anywhere near as much. Trim the shaft, if needed, so the upper hole in the head lines up with the hole in the main shaft. You should be good to go for the rest with stock parts. Go to the build thread I did and you will see how it can turn out with a 600EFL Pro, Nitro shaft, Century head, and Hangar 9 turnbuckles. Good luck.

Keyrigger is offline        Reply With Quote