View Single Post
Old 08-11-2018, 01:22 PM   #61 (permalink)
Registered Users

Join Date: Oct 2009

Hey Kalps, just a note before you go the direct solder route.

I have the same DM9 module, and had the same problem in my bay.
( I could even rock it back and forth slightly and make the signal cut out)
Seems like some DM9s are maybe molded a tad different, so it is hard to get a good lock on the pins.
After speaking with Raleigh and playing around a bit, I did end up solving it.
I ended up with 2 pieces of velcro inside bay, one at the "top" and one at "bottom" when looking straight into it.
This stopped all movement and made a solid connection, havent had a dropout after that.
Hope that helps
pigpen is offline        Reply With Quote