View Single Post
Old 08-11-2018, 09:02 PM   #62 (permalink)
kalps
Registered Users
 

Join Date: Jan 2008
Default

Quote:
Originally Posted by pigpen View Post
Hey Kalps, just a note before you go the direct solder route.

I have the same DM9 module, and had the same problem in my bay.
( I could even rock it back and forth slightly and make the signal cut out)
Seems like some DM9s are maybe molded a tad different, so it is hard to get a good lock on the pins.
After speaking with Raleigh and playing around a bit, I did end up solving it.
I ended up with 2 pieces of velcro inside bay, one at the "top" and one at "bottom" when looking straight into it.
This stopped all movement and made a solid connection, havent had a dropout after that.
Hope that helps

Would you have any pictures? Does the module clip in the bay after the Velcro insertion ?
Thanks

Last edited by kalps; 08-11-2018 at 09:05 PM.. Reason: Info
kalps is offline        Reply With Quote