A few final questions please.
1. I want to set up the CP2 on off to my Tx Gear switch. So that I get it correct first time could somebody let me know the Tx settings.
First you need to plug in the On / Off of the CPII into the gear channel.
In your Tx menu you'll need to locate the travel adjustment menu.
There you need to set Off position to 0, On position to 100
Also I want to continue use of the F mode switch to alter Pitch & Throttle but not Gyro.
2. Do I use the current gyro setting of 55 as a starting point in the CP2
Somewhere between 25%- 37% is a good range to work in, this can be adjusted in the preferences menu, scroll through till you get to gyro .
3. I currently use the RCHelicopterfun Pitch & Throttle curves which are very mild. Is it ok to continue with these. Also the D/R & expo are mild
4. Is it possible that the mild pitch curves and the D/R & Expo settings are causing me trouble when I setup the Flight control sticks. I can only get about 70%.
When setting up the CPII you should not have any D/R or expo set .
You can add it back after the setup is complete and test flown.
I hope that is it for a while.
Thanks
__________________
MSR x1 / mCPX x2 / 450 x4 / Chaos600 test bed / Chaos600 Air-Wolf / American WereWolf 800 / KFrame800/900/1000 / Assorted Fixed Wing
JR9303 / JR9503 / Futaba10CHP
|