View Single Post
Old 06-14-2019, 02:36 PM   #4 (permalink)
navigator2011
Registered Users
 
Posts: 2,325
 

Join Date: Apr 2011
Default

As to your question #2, go into your Main screen (Function List) and select "Mixing" to arrive at the following screen:



Select the line: P-Mix 1: INH > INH to display the Mix 1 screen. On the right-hand side of the Mix 1 screen, select Normal. Next, select GER > GER, set the Rate: to 100% 100%, and set Offset to 20%. Then, select a desired switch. I chose switch "I". Doing all this results in the following Mixing screen:



Upon selecting System Setup/Channel Assign, I find my Rx Port Assignments are:



Selecting Next shows that my Channel Input Configuration is:



Please not that I have not tested the I-switch to see if it works. I just fly the heli in 3D mode (Idle 2) all the time.

You should be able to set yours to the F-switch in System Setup/F-Mode Setup. For example, I have mine set to the G-switch. So, in the Channel Input Configuration screen above, I think you would select F for Channel 5, but I'm not totally sure. Maybe leave this setting for last.

In any case, I hope this helps.
Attached Thumbnails
Click image for larger version

Name:	20190614_120722.jpg
Views:	19
Size:	65.7 KB
ID:	798525   Click image for larger version

Name:	20190614_120735.jpg
Views:	196
Size:	71.8 KB
ID:	798527   Click image for larger version

Name:	20190614_120743.jpg
Views:	202
Size:	58.5 KB
ID:	798529   Click image for larger version

Name:	20190614_120832.jpg
Views:	200
Size:	61.8 KB
ID:	798531   Click image for larger version

Name:	20190614_120848.jpg
Views:	199
Size:	59.5 KB
ID:	798533  

__________________
navigator2011
Oxy3 255 / Oxy2 190 FE / Oxy2 190 Sport / Trex 150X / Brushless Nano S2 / Brushless Nano CPS / Spektrum DX9.
navigator2011 is offline        Reply With Quote