View Single Post
Old 11-15-2019, 02:10 AM   #132 (permalink)
kingries
Registered Users
 

Join Date: Nov 2019
Location: Netherlands
Default

Quote:
Originally Posted by P.I.Engineer View Post
I've flashed a few plush 10a in the past.

I just did my xk yesterday. The bootloader works. So after you flash you can remove the 3 wires and just connect through the servo plug. You just need signal and ground. You'll need to change your Arduino to a different interface as well and change the interface selection.
Goodmorning piengineer

Can you help me , i try yesterday this mod with my arduino uno but without succes.

i can connect to esc , but failed to esc 1 , it says esc seem to be disconnected or not powerup ?

i thought bad solder , i have try to solder 3 or 4 times , with the problem iam loosen my white pad on the esc

Is there an other way , how to flash blheli on it ?

Greetings Richard
kingries is offline        Reply With Quote