View Single Post
Old 01-15-2020, 02:24 AM   #13 (permalink)
HF Support
Posts: 36,283
Thread Starter Thread Starter
My HF Map location
Join Date: May 2006

I don't really anticipate printing with ABS, but I *do* have a potential project where nylon might be a good solution..

Just for giggles, I priced out an Ender 3 with a Duet WiFi controller, all metal hot-end, all metal extruder, BL Touch leveling module, glass plate etc.. I was very quickly past $600.. Way past where I really want to be..

Kinda leaning towards the CR-10 Mini at the moment with the addition of a BL Touch sensor... Still doing more reading.

No helicopters were harmed in the creation of this post.
AMA CD # 7309, Turbine Waiver# RW 890
Click Here For Bergen Intrepid Turbine Build Videos
Skiddz is offline        Reply With Quote