Thread: Jeti Gimbals
View Single Post
Old 08-24-2020, 02:53 PM   #1 (permalink)
meb882
Registered Users
 

Join Date: Jan 2019
Location: New Mexico
Default Jeti Gimbals

I was wondering if anyone has ever experienced any problems or had any issues with the gimbals in Jeti tx. I had an issue this weekend during my first flight which resulted in the total destruction of a NX7 . I don't believe it was a radio issue, but would like to cover all basis. I was flying a slow circuit just after take off and the helicopter went into full negative pitch with no input from myself. I tried to regain control of the machine with a positive collective input, the machine responded for no more than 2 to 3 seconds and then immediately returned to full negative collective consequently hitting the ground. There was no roll or pitch involved. I did a range check and there were no issues, also simulated a signal loss by shutting the down the transmitter and on one occasion removing the x-bus to the FBL, and on both occasions it just went into fail-safe. Any help or advise would be greatly appreciated.

Thanks
meb882 is offline        Reply With Quote