View Single Post
Old 05-13-2021, 05:02 PM   #5 (permalink)
nheather
Registered Users
Thread Starter Thread Starter
 

Join Date: Dec 2018
Location: Horsham, West Sussex, UK
Default

Worked out both my questions, well sort of.

Still no idea what adding two buttons to a function does.

But I've worked out the 3-Position RPM. Basically you setup RPM1 and RPM3 and leave RPM2 unassigned. Then the software just assumes that if you haven't got RPM1 or RPM3 selected then you must want RPM2.

Works a treat.

And the FBL settings - well funnily enough, go into Workbench, select the FBL controller from the parts on the left and there are the settings - knew I'd seen them.

Cheers,

Nigel
nheather is offline        Reply With Quote