View Single Post
Old 06-15-2021, 11:19 PM   #3 (permalink)
Dylan Hudock
Registered Users
Posts: 2,146

Join Date: Jun 2011

Just cut the shaft down. Put the motor in a ziploc bag, and poke the shaft out through a corner. This is very important as to avoid getting metal shavings inside the motor. Just use a dremel cutoff wheel and take it slow, it really is no big deal at all. Ensure you mark the shaft before cutting to allow enough to engage all of the pinion support bearing and you'll be good to go.
Team Synergy
Dylan Hudock is online now        Reply With Quote