View Single Post
Old 12-04-2008, 10:23 PM   #22 (permalink)
Ozydego
 

Join Date: Feb 2006
Default Setup update from Assurance

Setup per manual
11. Now Limit LED lights up.
12. Move the rudder stick and observe your tail pitch travel. Move the rudder stick left until the tail pitch slider reaches the end, then move to the right until pitch slider reaches the other end.
13. While holding the rudder stick, press SET button on gyro.

Setup per Assurance

11. Now Limit LED lights up.
12. Move the rudder stick and observe your tail pitch travel. Move the rudder stick LEFT until the tail pitch slider reaches the end,
13. While holding the rudder stick at that spot, press SET button on gyro.
14. Finish the setup, then go BACK through the setup process again, but this time, Move the rudder stick RIGHT until the tail pitch slider reaches the end,
15. While holding the rudder stick at that spot, press SET button on gyro.
16. Now finish the original instructions


A customer was having issues with his tail limits, he was always having binding with the servo. We went through the setup a few times without luck and finally called Assurance. They corrected the setup procedure over the phone and that fixed the problem. The real issue in the end that caused the binding in the first place was the ball end being 12mm out from center instead of 5mm like the manuals states. This caused the limits to be out of whack and thats when we noticed the original procedure to not work.
Ozydego is offline        Reply With Quote