Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > Blogs


Old

Heli-Log 3:22:2020

Posted 03-22-2020 at 07:50 AM by rcnut

March, almost finished…this time!


Sygnergy G696Z…


I pulled the motor to inspect the clutch. My thought was the shoes was too tight/sticking. Well, it was somewhat, and that was an easy fix...but not the main problem. It was the one way in the main gear. So I need to pull the main gear out and see why the one way is backwards. Either I did this while reassembling the gear, after Loctiting everything, not paying attention, or the one way is simply installed...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 31 Comments 0 rcnut is offline
Old

Heli-Log 3:22:2020

Posted 03-22-2020 at 07:15 AM by rcnut

[bMarch, and the build continues…[/b]


Sygnergy G696Z…


I installed the main blades and zero’d them. I moved through the programming finishing the swashplate menu. I finalized the wiring (took a little longer than I thought), and made up a power wire for the LiPo pack to run from the front to the back.

I started in with the canopy, making sure it would fit properly, and with my wiring placement. The front canopy pins were not out (spacing...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 16 Comments 0 rcnut is offline




Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1