Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > Blogs > JonJet


Rating: 2 votes, 5.00 average.

mCPX & mCPX BL Interchangeable Parts

Posted 05-17-2015 at 09:30 PM by JonJet
Updated 05-28-2015 at 10:01 AM by JonJet

The following parts will swap back and forth between the mCPX and mCPX BL

Canopy (from mCPX BL to mCPX)

Blade Grips - Rotor Hub - Feathering Shaft (the BL parts are much stronger)
Main Shaft - Main Gear - Shaft Collar - Main Bearings
All servos - assuming the long wire type is used

Servo Rods

If the mCPX Swash is used - use the mCPX head links
If the mCPX BL Swash is used - use the BL head links

The following parts do not interchange
3-n-1 boards

Main Frame
Main Motor
Tail Boom

Tail Motor
Tail Motor Mount
Tail Rotor
Landing Gear

Wire harness from the mCPX BL can be used on the mCPX...just remove any outer wire (watch for proper ccw rotor rotation)

Main Blades can be swapped - mCPX main blades on the mCPX BL will decrease lift and disk area - opposite results for the mCPX BL blades on a mCPX
Posted in mCPX & mCPX BL
Views 812 Comments 0
« Prev     Main     Next »
Total Comments 0

Comments

 




Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1