Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > Blogs


mCPX BL vs. mCPX BLHeli

Posted 05-19-2015 at 02:18 AM by JonJet
Updated 07-01-2015 at 06:57 AM by JonJet

I just did a test flight using the Xtreme 130X main blades on My mCPX BL running BLHeli software to drive the tail...

Even as low as 40-flat TC, it jumps like crazy when I pump the collective and the tail holds perfectly...(Lynx 47mm tail blade)

A bit of servo travel tuning should help curb the floaty feeling, but wow, what a difference even at such low TC
JonJet's Avatar
Registered Users
Posted in mCPX & mCPX BL
Views 323 Comments 0 JonJet is offline

Blade Micro's - Extended Booms

Posted 05-17-2015 at 10:11 PM by JonJet

The following is a list of extended tail boom part numbers and lengths that I have used successfully

mSRX - BLH3602 - 125mm
nCPX - BLH3602 - 125mm
mCPX - BLH3602L - 150mm
mCPX BL - roughly 155-170mm
JonJet's Avatar
Registered Users
Views 321 Comments 0 JonJet is offline
Rating: 2 votes, 5.00 average.

mCPX & mCPX BL Interchangeable Parts

Posted 05-17-2015 at 09:30 PM by JonJet
Updated 05-28-2015 at 10:01 AM by JonJet

The following parts will swap back and forth between the mCPX and mCPX BL

Canopy (from mCPX BL to mCPX)

Blade Grips - Rotor Hub - Feathering Shaft (the BL parts are much stronger)
Main Shaft - Main Gear - Shaft Collar - Main Bearings
All servos - assuming the long wire type is used

Servo Rods

If the mCPX Swash is used - use the mCPX head links
If the mCPX BL Swash is used - use the BL head links

The following parts do not interchange
JonJet's Avatar
Registered Users
Posted in mCPX & mCPX BL
Views 810 Comments 0 JonJet is offline

Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1