Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > Blogs > nickyd


Rate this Entry

20.3.14

Posted 03-20-2014 at 09:11 AM by nickyd
Updated 03-25-2014 at 10:03 AM by nickyd

Main shaft swapped for used but good one.
Leave feather shaft as is.
set to vibe logging..
Tail vibe =2.3 with no mains.
Fit used but good tail slider: still 2.3 tail freq vib
1.3 tail vibe with no tail blades .
fit new boom. still 1.3 as above

Cntr DS95 faulty: spinning: pot had come loose. glue into place with j-b weld:all ok.

blades track at zero derees zero stick.

auto beeper fitted to dx7.

spool up on towel with mains and tail blades. lcd vib=0.3 (vib log shows peaks of 1 and 2.4 for main and tail)

Seal GPS cover due to inverted rescue been at a lower altitude

Set 2nd cyclic bank to CS inverted (Selected when in GPS mode)

Fit push button switches to DX7 (RHS parallel to AUX2, LHS Parallel to Gear)

Hover vibe =1.3 on Playback log
Posted in Uncategorized
Views 508 Comments 0
« Prev     Main     Next »
Total Comments 0

Comments

 




Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1