Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > Blogs


Old

05-12-13

Posted 12-05-2013 at 04:41 AM by nickyd
Updated 12-08-2013 at 04:15 PM by nickyd

Fit second bearing to torque tube drive shaft. Equally space the two bearings ( by eye).

Hover: vibe score=0.2

analysis gives 0.8 on motor, head and tail

Fit esc programming link. Test. Still have to disconnect receiver to activate software.
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 561 Comments 0 nickyd is offline
Old

28-11-13

Posted 11-28-2013 at 07:12 AM by nickyd
Updated 12-02-2013 at 03:58 PM by nickyd

increase gap between motor pinion and Main. Set much more than paper test.
Shorten Torque Tube by 1mm ( Need to cut to go shorter).
lube head with vaseline.
pack gap at front of motor mount.
vibe: 0.4 first hover
0.2 second hover.

see up-down motor vibe . this may be play in motor mount. need to bolt down front of mount.

front of motor mount now screwed down. vibe=0.2 on ground (vibe analysis shows motor up-down vibe more than halved) slight...
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 573 Comments 0 nickyd is offline
Old

10-11-13

Posted 11-10-2013 at 05:17 PM by nickyd
Updated 11-17-2013 at 12:25 PM by nickyd

2216-3350 motor fitted.
Flies well.

No vibe improvement, however v breezy

Fly again when calm. 1.5 vib
tighten tail and mains. no differnce.

Confident clean Rolls and inverted straight runs.
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 653 Comments 0 nickyd is offline
Old

1-11-13

Posted 11-03-2013 at 02:20 AM by nickyd
Updated 11-05-2013 at 04:43 PM by nickyd

install metal servo mounts and torque tube bearing rubber.

2 flights . 1.1vib

install new owb
install new plastic washout base
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 559 Comments 0 nickyd is offline
Old

26.10.13

Posted 10-26-2013 at 08:01 AM by nickyd

Fit new dampers and tail blades.

2 flights.
2700rpm vib=.7
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 596 Comments 0 nickyd is offline




Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1