Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > Blogs


Old

21-9-13

Posted 09-22-2013 at 12:33 AM by nickyd

3 good flights. Inverted for a few seconds with some elevator control. Slow flips getting better.
Windy blustery. Vibe. 0.7, 0.9
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 534 Comments 0 nickyd is offline
Old

18-9

Posted 09-17-2013 at 11:23 PM by nickyd
Updated 09-18-2013 at 06:14 AM by nickyd

Re-level swash and adjust travels for +- pitch level swash.
Servo balls now 15mm.
had to increase rh servo travels in order to keep level swash at full pitch range.
travels around +-125 now
swash mix around 60-60-43
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 538 Comments 0 nickyd is offline
Old

SK Swash Setup wrt DS95 : Tech notes

Posted 09-17-2013 at 06:06 AM by nickyd

https://www.helifreak.com/showthread.php?t=267215

Dear customers,
Several customers reported that our servo does not work well with the MicroBeast. The servo might be trembled or worked feebly.
Some customers reported that the MKS servos do not work well with the MicroBeast. When the aileron and elevator working together at the same time and the pith was pushed to limitation, our servo might work tremblingly or feebly. We think the reason is that the working range was out
...
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 513 Comments 0 nickyd is offline
Old

15-9-13

Posted 09-15-2013 at 01:51 PM by nickyd
Updated 09-16-2013 at 05:57 AM by nickyd

Re-setup cyclic:
Move servos out on brackets and move balls out one hole.
Set swash travels to 125% and now get full +-12pitch and +-9.5cyclic.
Test fly and all ok.
Very windy and vibes 1.3 foirst flight, then 0.6 second flight ???
HF advises that DX6i Travel Adjusts have no effect on servo travel with SK.
Set DR 1 to 95% instead of 100 to stop possible interaction.

Flying: Loops bigger and better. Inverted - some in a straight line for 5 seconds...
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 464 Comments 0 nickyd is offline
Old

14-09-13

Posted 09-14-2013 at 12:38 AM by nickyd
Updated 09-14-2013 at 02:09 PM by nickyd

  • replace feathering shaft and re-grease bearings.
  • set 260 cyclic control rates. no big difference
  • vibes =0.6 no change . good flights but see tail slight twitch. lower sk gov gain and its stlll there. go back to Ice gov.
  • set 280 cyclic rates
  • 2700 and 2800rpm
  • photos are too dark. need to adjust??

no twitch on tail from ice gov
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 466 Comments 0 nickyd is offline




Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1