Fun, Learning, Friendship and Mutual Respect START  HERE


Unregistered
Go Back   HeliFreak > Blogs


Old

27-04-15

Posted 04-27-2015 at 07:11 AM by nickyd

4 Flights - Uses new 60C packs- seem good but not much difference to the old packs on a pitch pump.

Inverted hovering 2 foot from the grass
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 613 Comments 0 nickyd is offline
Old

Heli-Log 4:21:2015

Posted 04-21-2015 at 02:41 PM by rcnut

Well, April is quickly leaving us! Just over one week left and…

Ok as a re-cap… My Synergy N7 had several issues I have finally worked out! (fan hub, foam tape on the VX1n, and the O.S. carb problems) The O.S.105HZ-R problem is finally gone; however, the motor is no longer a pumped motor, just an O.S.105HZ. I tried almost every combination with the pumped motor version and couldn’t get it tuned right; it was close…but never there. I tried using the carb from a blown up O.S.91HZ motor...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 389 Comments 0 rcnut is offline
Old

Heli-Log 4:13:2015

Posted 04-13-2015 at 04:01 PM by rcnut

April! Ah yes, the smell of spring and the birds chirping once again!

After the B-Ham fun fly, I went through some of my helis to prepare them for the next time out to the flying field. The Synergy, I removed the main needle valve and regulator. I disassembled both and used alcohol to thoroughly clean everything. I may have found some tiny bits of junk in the regulator sitting on the clean paper towel I was using.

The second Goblin gasser, I removed the factory tape...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 382 Comments 0 rcnut is offline
Old

Heli-Log 3:30:15

Posted 03-30-2015 at 10:48 AM by rcnut

Now it’s almost the end of March! Come on warmer weather!!!

Well my N7 dilemma continued until Friday the 20th. I dropped the motor only to find the hub was spinning on the motor shaft. A check of the nut…and it was tight! Great, I trashed the hub, but wait, there’s more! I thought I had shrunk down (crushed) the hub enough that it would spin with enough torque from the motor. So I tried to use a washer under the nut.

That didn’t work, the hub spun off the second I...
rcnut's Avatar
Registered Users
Posted in Uncategorized
Views 403 Comments 0 rcnut is offline
Old

11-03-15

Posted 03-11-2015 at 08:05 AM by nickyd

change expo bup to 25% since had blade strike on landing during first flight of season.
nickyd's Avatar
Registered Users
Posted in Uncategorized
Views 728 Comments 0 nickyd is offline




Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1