HP07-2 Motor Review - HeliFreak
Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > R/C Helicopter Support > Walkera Helicopters > 4G6 / V120 Series

4G6 / V120 Series Walkera 4G6 / V120 Series Helicopter Support

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 10-09-2010, 02:46 AM   #11
Registered Users
My HF Map location
Join Date: May 2010
Location: melbourne, australia


1. with a brushless motor there is no need for colour codeing the wires.
connect the three wire, and if it spins the correct way
if it spins the wrong way, switch only two of the wires around, and it will reverse the direction

2. it should only be the last ~1/2 inch that is bare, and will have solder on it already.
the "naked" wire you are looking at should have a clear coating to insulate it

ado1974 is offline        Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Copyright © 2004-2016 by RCGroups.com, LLC except where otherwise indicated. The HeliFreak.com logo is a trademark of RCGroups.com, LLC.