Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > R/C Helicopter Support > Mikado Logo Helicopters

Mikado Logo Helicopters Mikado Logo Helicopters Discussion

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 05-05-2012, 12:39 AM   #1
Registered Users
Posts: 498

Join Date: Dec 2010
Location: Burgas, Bulgaria
Default Logo 400 motor plate

I am talking about the logo 400 motor plate (MIK4170). When it came brand new the bearing didn't spin quite as nicely as the top one but it was good enough. Now, when I go mod .7 and I disassembled the heli I noticed there is a spot where it does not spin but more like jams over it. It is still flyable but I am thinking it is best to replace it.

Now, Mikado does not specify what type of bearing it is but I am pretty sure it is MIK1329 (10x19x5). Question is, did anyone already tried to replace that bearing and how did it go ? Is it glued with some loctite ? Does it go out freely ? I am thinking to put the plate on a flat surface and use some larger diameter shaft to force it to go out.

One thing is, I don't want to bent the plate or somehow make it unusable because it is expensive and the bearing is still flyable anyway. I could leave it and try to find some bearing removal tool in the mean time.
Kalpazan is offline        Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Copyright © 2004-2016 by, LLC except where otherwise indicated. The logo is a trademark of, LLC.