Hex starter adapter help! - HeliFreak
Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > R/C Helicopter Support > Antique Out of Production and Vintage Helicopters > Outrage RC

Outrage RC Outrage RC - and XP Li-Po Factory Support Forum

Thread Tools Display Modes
Old 06-25-2012, 03:08 PM   #1
Registered Users

Join Date: Jun 2009
Location: Woodbridge, Va
Default Hex starter adapter help!

My new velo 50 flybarless kit came with a clamp style hex starter and it will not tighten down on the shaft enough to turn the engine. I see in the manual it is pictured with a set screw which would solve the problem. Did I get the wrong one with my kit? Can not get through on outrage's website customer service. Please help! Thanks

bjames is offline        Reply With Quote
Old 06-25-2012, 06:04 PM   #2
Registered Users
Posts: 1,377

Join Date: May 2010
Location: Msct mde

I used to fix the Trex 700 starter bullet on my velocity 90. Am not sure but as far as i can remember the v90 & v50' starter bullets are interchangable. So the Align bullet should just work fine on your 50. As i said am not sure so just check for the diameter.

The clamping style is the old type never worked with me either but i remember that shaft and its bullet were revised and there is a better one in the market.

Sent from my GT-N7000 using Tapatalk 2
saeed09 is offline        Reply With Quote
Old 06-30-2012, 03:10 PM   #3
Registered Users
Posts: 6,612
My HF Map location
Join Date: Oct 2008
Location: Cape Coral, FL, USA

sounds like the wrong one. Check with the distributor.
im4711 is offline        Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Copyright © 2004-2016 by RCGroups.com, LLC except where otherwise indicated. The HeliFreak.com logo is a trademark of RCGroups.com, LLC.