![]() |
START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
KDS Electronics KDS Electronics Discussion |
![]() |
|
LinkBack | Thread Tools | Display Modes |
![]() |
#1 (permalink) |
Registered Users
Join Date: Sep 2011
|
![]() I setup the Ebar according to manual and some online help.
now I connected the motor to the ESC and the HW ESC is beeping. according to the manual it cant see the min throttle position. I tried to recalibrate the throttle range but it wont respond. any idea of the cause I use Spektrum AR8000 receiver with Sat Remote connected to DX8 |
![]() |
![]() ![]() ![]() ![]() |
Sponsored Links | |||
Advertisement |
|
![]() |
#2 (permalink) |
Registered Users
Thread Starter
![]() Join Date: Sep 2011
|
![]() after few trials
I seem to get the ESC to connect by: Ebar PIT/ESC port is connected to BND/DAT port on the receiver ESC is connected to Throttle port on the receiver this somehow does not make sense, by the fact that the receiver is driving the ESC instead of the EBar. is this right? |
![]() |
![]() ![]() ![]() ![]() |
![]() |
#3 (permalink) |
Registered Users
Join Date: Dec 2014
|
![]() sounds normal for a non-sbus setup. I had to do it as well when i decided to use the regular A.E.R cables to plug into a JR DMSS system as well. Had throttle connected to the receiver instead of the FBL.
__________________
KDS Chase 360 // Agile 5.5 // Agile 7.2 SAB Goblin 380 // 630 |
![]() |
![]() ![]() ![]() ![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|