![]() |
START HERE |
|
Register | FAQ | PM | Events | Groups | Blogs | Calendar | Mark Forums Read |
Unregistered
|
Open Source Flight Controllers (CC3D, Ardupilot, etc.) Open Source Flight Controllers (CC3D, Ardupilot, etc.) |
![]() |
|
LinkBack | Thread Tools | Display Modes |
![]() |
#1 (permalink) |
Registered Users
Join Date: Oct 2014
|
![]() I have a CC3D i just started to test, just to find out the large Female JST on CC3D board is loose. Its connected only on the one side so i must hold the JST itself to be able connect male JST with cables going to Rx. I only get power to Rx via JST if i push the Female JST quite hard down to CC3D board. How i should fix this?
Nikki
__________________
Rave90ENV - Frenzy 600/700 E DFC- Align Trex 500E - Copterx 360 BA DFC |
![]() |
![]() ![]() ![]() ![]() |
Sponsored Links | |||
Advertisement |
|
![]() |
#2 (permalink) | |
Registered Users
Join Date: Mar 2014
|
![]() Quote:
__________________
I give up on signatures. |
|
![]() |
![]() ![]() ![]() ![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|