Power Supply - Page 2 - HeliFreak
Fun, Learning, Friendship and Mutual Respect START  HERE

Go Back   HeliFreak > R/C Electronics Support > FMA/Revolectrix Product Support

FMA/Revolectrix Product Support FMA/Revolectrix Factory Product Support

LinkBack Thread Tools Display Modes
Old 10-06-2017, 11:21 AM   #21 (permalink)
Registered Users

Join Date: Sep 2004
Location: USA

It's trivial to fix, just adjust the power supply voltage up or down so the charger will remain in buck or boost mode for the entire charge cycle.

It's important to note buck/boost transitions affect all chargers.
Ace Dude is online now        Reply With Quote Quick reply to this message
Sponsored Links
Old 10-12-2017, 07:30 PM   #22 (permalink)
Registered Users
Posts: 1,754

Join Date: Mar 2011
Location: Spain

So is that the buck/boost thing that makes the chargers amperage go crazy up and down? I have two psu in series with a 25.7v output, under big load drops to 25.4v and that might be too close to the 6s max voltage. But then I cranked the PSU as high as I could to 26.5v. Still at around 70% into the charge the voltage drops to 26.2v and the output amperage began fluctutating up and down. I thought it would be ok to stay above 26v...

Edit: OK, just read it in the manuals for PL6 and PL8. For maximum output PL8 needs 26.35v input but PL6 is asking for 30.0v. Interesting...
Oxy3 - Trex 500 - eXo

Last edited by Mateyhv; 10-12-2017 at 07:53 PM..
Mateyhv is offline        Reply With Quote Quick reply to this message
Old 10-13-2017, 11:11 AM   #23 (permalink)
Registered Users
Posts: 632
Thread Starter Thread Starter

Join Date: Jun 2012
Location: Madison, MS

Supply PS voltage will vary +- as load is applied to the PS. Normally less than a volt. The charger will maintain charge rate with minor supply fluctuations.

The reason buck boost is suggested is two PS at 24-25v are close to lipo battery volts. The charger has to boost supply volts or fluctuates doing so during charge. If your running a generator and runs a consistent load your fine

Follow up,
In the meantime hoping for a nugget of wisdom. Discounting buck-boost due to constant supply (meaning PS & Gen.) only variation is one or two chargers operating well under capacity. Bought another charger brandthat begins with an I, 4010 duo.

Re-wired my PS 4ea in series to 48v (50.7v actual).

Two tests, same as PL6. (PL6 limited to 40a supply). Both channels at 20A:

4 PS, supply 50.6v, charge 19.8-20v @18.9a and 75% gen loadno surging.
2 PS of the 4 powered, supply 22.6v, charge 19.8-20v @47a and 95% gen load no surging. If buck boost was the cause this be the time.

I'll miss one button charge start.

Gaui x5, x5, Rush 750 - Ikons, x7 - CGY750, 14SG
DanMcN is offline        Reply With Quote Quick reply to this message

Quick Reply

Register Now

In order to be able to post messages on the HeliFreak forums, you must first register.
Please enter your desired user name, your REAL and WORKING email address and other required details in the form below.
User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.
Confirm Password:
Email Address
Please enter a valid email address for yourself. Use a real email address or you will not be granted access to the site. Thank you.
Email Address:
Where do you live? ie: Country, State, City or General Geographic Location please.
Name and Lastname
Enter name and last name here. (This information is not shown to the general public. Optional)
Helicopter #1
Enter Helicopter #1 type and equipment.
Helicopter #2
Enter Helicopter #2 type and equipment.
Helicopter #3
Enter Helicopter #3 type and equipment.
Helicopter #4
Enter Helicopter #4 type and equipment.


Human Verification

In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in the graphic.

Thread Tools
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Copyright © Website Acquisitions Inc. All rights reserved.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.

SEO by vBSEO 3.6.1