Jeti mezon 90 lite

[PKNEC]

Ok due to having some issues with the HW platium 100 amp esc that is now going back to the retailer.
I am considering fitting a jeti mezon I have lying around so I can continue with the build.
Have any of you folks had any experience with this esc in a G500 sport setup.
All electronics are stock that came with the combo.
FBL is Brain 2
Any advice greatly appreciated

[henke2]

Hi,

I run a mezon 165 on my Sport 500. It uses around 130Amps peak and 100A on regular basis. The ESC serves me well and I love the telemetry and logging via the Jeti DS16.

I recently found the governor gain and are tuning it now. Works really well I must say.

[PKNEC]

Originally Posted by henke2

Hi,

I run a mezon 165 on my Sport 500. It uses around 130Amps peak and 100A on regular basis. The ESC serves me well and I love the telemetry and logging via the Jeti DS16.

I recently found the governor gain and are tuning it now. Works really well I must say.

So it looks like my 90 is a bit under gunned based on your figures.

[K2Freak]

I have never owned nor have I run a Meson 90, but the numbers make it a perfectly reasonable choice for a G500. You are not likely to pull 90A continuous (at least not for long), and you will (hopefully) never pull 300A peaks.

[henke2]

Quantum 4120 1200, Stock 500mm blades, 18T pulley. No hard 3D but doing flips, piros, loops and stuff. 2700rpm and flight time was a little over 6minutes on my 5000mAh pack. (I run it to about 4500mAh).

ESC started at 22 Celsius and ended at 44 Celsius, with 5 degrees Celsius outside. But again, it's the 165 I have.

Fresh from today :-)