TELME VS FUTABA T10J

[piero80]

hi I wanted to know if the telme kontronik is compatible with transmitter futaba t10j and receiver r3008sb with transmission module t-fhss, I state that I have already updated the firmware of the kosmik 200 to 4.10.
Thank you so much for your help

[Wh1teAfr1can]

Originally Posted by piero80

hi I wanted to know if the telme kontronik is compatible with transmitter futaba t10j and receiver r3008sb with transmission module t-fhss, I state that I have already updated the firmware of the kosmik 200 to 4.10.
Thank you so much for your help

did you ask in the futaba forum? if it is not on their sensor list then it probably isn't supported on that radio.

[Wh1teAfr1can]

Originally Posted by Wh1teAfr1can

did you ask in the futaba forum? if it is not on their sensor list then it probably isn't supported on that radio.

the compatible transmitters on the Kontronik website are as follows:

T18MZWC (T18MZ)
T18SZ
T16SZ
T14SG
FX-22

[piero80]

hi guys I wanted to know how to connect my kontronik kosmik 200 to the flybarless control unit msh brain 2 to see the telemetric data of the controller via brain2, the transmitter and the futaba t10j with receiver r3008sb thanks in advance

[Wh1teAfr1can]

Originally Posted by piero80

hi guys I wanted to know how to connect my kontronik kosmik 200 to the flybarless control unit msh brain 2 to see the telemetric data of the controller via brain2, the transmitter and the futaba t10j with receiver r3008sb thanks in advance

That setup is not supported for telemetry, unless the brain can take input from some 3rd party translation module like a Jlog.

[piero80]

no do not communicate with each other, I'm looking for another way through the brain2 but I do not know how to connect them to each other for telemetry.

[BrainDev]

Originally Posted by piero80

hi guys I wanted to know how to connect my kontronik kosmik 200 to the flybarless control unit msh brain 2 to see the telemetric data of the controller via brain2, the transmitter and the futaba t10j with receiver r3008sb thanks in advance

Originally Posted by Wh1teAfr1can

That setup is not supported for telemetry, unless the brain can take input from some 3rd party translation module like a Jlog.

Instead it is fully supported by Brain2 as explained in the telemetry documentation of Brain2 at page 2 (Kosmik ESC) and page 4 (Futaba transmitters):
http://updatebrain.mshbrain.com/soft..._telemetry.pdf

Problem is only that Kontronik have not yet officially released the new firmware for his ESC's with the new telemetry protocol. New Kontronik ESC firmware's, are ready from October (used under NDA for development and tests with Brain2).