Register Now

squibcakes · 02-06-2018, 11:24 PM

Does the old 5.3 full size Vbar support SRXL single line protocol?

newbheliusr · 02-06-2018, 11:36 PM

If it's anything like sbus then yes. But I could be wrong

But here's the mikado link
Wiring your VBar | VStabi

Vinger · 02-07-2018, 12:54 AM

Nearly all single line protocols are supported, but have not seen anywhere that they support SRXL, but if the Spektrum serial communications support UDI then it will work as VBar has support for UDI. Otherwise just use Spektrum satellites

squibcakes · 02-07-2018, 06:12 PM

I haven't seen anything either from Mikado. Nothing on their website which looks like it hasn't been updated in years.

I'm thinking of using the Spektrum AR7700 single line receiver. It does output either SRXL or Remote receiver output.

It would be nice to know if either of those are supported by Vbar Blue.

I suspect it probably would support the Remote receiver single line output from the AR7700 but would it connect to the Aux input or Sat input??

Vinger · 02-07-2018, 09:58 PM

Single line connections are all through AUX 1
Wiring your VBar | VStabi

Rabid121 · 02-08-2018, 08:22 AM

Quote:

Originally Posted by squibcakes

...I suspect it probably would support the Remote receiver single line output from the AR7700 but would it connect to the Aux input or Sat input??

i do have several birds flying with AR7700 connected to VBar Silverline or VBar Mini. all are connected the same way: AR7700 Remote RX => Sat (RX1) on vbar. config on VBar side like with spektrum sat.

you have to solder a simple cable for this: ground/signal *only* to be connected.... no + (!!! connecting it could burn the RX1 on vbar)

to power up the AR7700 a second connection is necessary: ground/plus (no signal) from any vbar connector to AR7700.

=> working great with TM1000 + JLog32 in my case. could not be happier

Ciao
Michael

squibcakes · 02-08-2018, 06:06 PM

Hallo Michael,

That is really good news. Thanks for the tip about not connecting the power wire when connected to Sat input.

Out of interest, did you ever try connecting the AR7700 (Remote receive cable all three wires) directly to the (AUX 1, Sliverline, RX C, Mini) pins of the VBAR instead of the Sat input on the VBar?

Cheers
Squib

Rabid121 · 02-09-2018, 02:51 AM

i tried once directly when the AR7700 got available... did not "immediately" work, so i connected RX1 and did not spend further time trying. based on experience reports in German forums this was the only way at this time (late '15/early'16)...

Ciao
Michael

02-06-2018, 11:24 PM	#1 (permalink)
squibcakes Registered Users My HF Map location Join Date: Feb 2008	Blueline support SRXL??? Does the old 5.3 full size Vbar support SRXL single line protocol? __________________ The flight isn't complete until the blades stop turning... [Trex 600N, V-Bar] [Trex 450ProV2, 3Gx] [Trex 470LM Microbeast Plus]

02-06-2018, 11:36 PM	#2 (permalink)
newbheliusr Registered Users Join Date: Apr 2011	If it's anything like sbus then yes. But I could be wrong But here's the mikado link Wiring your VBar \| VStabi __________________ Heli's I have: Goblin 500 (Vbar Neo), Gaui X5(Vbar Neo), X7(Vbar Neo), Innova 600 Night heli (Vbar Neo Vbar Vcontrol I'm the not so newbheliusr as I have been here a while. But I like this name.

02-07-2018, 12:54 AM	#3 (permalink)
Vinger Registered Users My HF Map location Join Date: Sep 2007	Nearly all single line protocols are supported, but have not seen anywhere that they support SRXL, but if the Spektrum serial communications support UDI then it will work as VBar has support for UDI. Otherwise just use Spektrum satellites __________________ Henseleit TDR, TDR2, TDF, TDS, TDSF Kontronik, Scorpion ESC, iChargers, VBar, VControl Old hand at Planks Peter

02-07-2018, 06:12 PM	#4 (permalink)
squibcakes Registered Users Thread Starter My HF Map location Join Date: Feb 2008	I haven't seen anything either from Mikado. Nothing on their website which looks like it hasn't been updated in years. I'm thinking of using the Spektrum AR7700 single line receiver. It does output either SRXL or Remote receiver output. It would be nice to know if either of those are supported by Vbar Blue. I suspect it probably would support the Remote receiver single line output from the AR7700 but would it connect to the Aux input or Sat input?? __________________ The flight isn't complete until the blades stop turning... [Trex 600N, V-Bar] [Trex 450ProV2, 3Gx] [Trex 470LM Microbeast Plus]

02-07-2018, 09:58 PM	#5 (permalink)
Vinger Registered Users My HF Map location Join Date: Sep 2007	Single line connections are all through AUX 1 Wiring your VBar \| VStabi __________________ Henseleit TDR, TDR2, TDF, TDS, TDSF Kontronik, Scorpion ESC, iChargers, VBar, VControl Old hand at Planks Peter

02-08-2018, 06:06 PM	#7 (permalink)
squibcakes Registered Users Thread Starter My HF Map location Join Date: Feb 2008	Hallo Michael, That is really good news. Thanks for the tip about not connecting the power wire when connected to Sat input. Out of interest, did you ever try connecting the AR7700 (Remote receive cable all three wires) directly to the (AUX 1, Sliverline, RX C, Mini) pins of the VBAR instead of the Sat input on the VBar? Cheers Squib __________________ The flight isn't complete until the blades stop turning... [Trex 600N, V-Bar] [Trex 450ProV2, 3Gx] [Trex 470LM Microbeast Plus]

02-09-2018, 02:51 AM	#8 (permalink)
Rabid121 Registered Users Join Date: Oct 2011 Location: ~Vienna, Austria	i tried once directly when the AR7700 got available... did not "immediately" work, so i connected RX1 and did not spend further time trying. based on experience reports in German forums this was the only way at this time (late '15/early'16)... Ciao Michael __________________ our hangar: minicopter helis, YGE/Spirit/Futaba BLS/Jeti

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Register Now

Log-in