Cyclic servos not moving 3Digi

[toadiscoil]

Hi there,

I have a very weird issue. This is my first try at a 3Digi unit I am a Brain user.

I went through the setup everything looks ok. I was able to use the manual subtrim to level the swash. However on any other step the servos don't move at all from transmitter input. I check on the transmitter tab and I see the channels moving, so the 3Digi is receiving the transmitter inputs. When the main pack is connected, the servos do this big "dance" in a circle and the swash ends up tilted to the front. Actually if I go to the gyro compensation tab, the gyro moves the servos. Even more odd, I can move and adjust my tail endpoints without any issues.

What am I missing? Please advise.

Cheers,

[Dowquest]

Originally Posted by toadiscoil

Hi there,

I have a very weird issue. This is my first try at a 3Digi unit I am a Brain user.

I went through the setup everything looks ok. I was able to use the manual subtrim to level the swash. However on any other step the servos don't move at all from transmitter input. I check on the transmitter tab and I see the channels moving, so the 3Digi is receiving the transmitter inputs. When the main pack is connected, the servos do this big "dance" in a circle and the swash ends up tilted to the front. Actually if I go to the gyro compensation tab, the gyro moves the servos. Even more odd, I can move and adjust my tail endpoints without any issues.

What am I missing? Please advise.

Cheers,

do you have the rescue activated/setup? you may have to invert the channel .

[toadiscoil]

Found my issue. I fed power into the GOV port, contrary to my experience on Brain. I have redone the connector and plugged secondary BEC to CH4 now. Seems to work fine just need to test fly.