New Blade 120 S2

[justjay82]

Hi guys,

First day using the 120 S2, and the little black plastic connector that holds the branded body to the hard plastic body of the heli snapped off on both sides.

I cant post a photo yet.

What should I do? My first thought was glue it, but I'm not sure if that's the right approach, or if there's something else you guys can recommend.

Thanks!

[Thomas.Heiss]

Do you mean the canopy pin?

So you can't clip the canopy onto the main frame anymore?

[Chickenhawk201]

If your speaking of the parts that attached to the area (circled in green),they are a 3-pc affair and just need to be reassembled.

Now if your speaking about the lower canopy pins (circled in red), you could very carefully drill a small hole on each side where the pins used to be and run a very small rod through it..

As you just purchased the helicopter, If I were in your shoes; I would buy a new Main Frame (Part# BLH4104) for about $9.00 on Amazon. Though it's going to be a bare-bones frame; You'll learn a lot about your 120 S2 taking it apart and putting it back together.

If you do a Google search for "The unofficial Blade 120 S and 120 S2 thread" you'll learn a lot about your 120 S2, and support is just a post away.

Congrats and welcome to the Blade 120 series of helis.

Chickenhawk